When a signal reaches the point of clipping, speaker cones do not move, as the clipped signal is essentially a DC signal for the duration that it exceeds the voltage rail boundaries. This causes all of the power from the amplifier to be used towards heating the voice coils instead of producing sound. Skip to main content. Mackie Blog. What is Clipping? May 22, Facts about clipping: Any clipped signal can potentially damage a speaker.
If the aforementioned is happening your amp is clipping, and we know what happens to those who clip. While playing the system at the predetermined max volume with an occasional flicker on the clip indicator see steps , start edging up the subsonic filter up until the sound audibly changes. Depending on how far it was moved, you may see the clip indicator no longer flickering. Now you can turn the amp gain up until the clip indicator starts to flicker again.
Keep in mind if your Subsonic and LPF filters are set too closely together you will greatly limit your amps musical output. Amplifier Setup: Gain Setting- 1. Set LPF to Hz 2. Set Subsonic to Hz 3. To fully eliminate any clipping, you may have to set the gain lower than you would like, and in that case, there are some other things you can try. Seeking out more efficient speakers is another way to get higher volume levels from your amp without requiring as much power.
We hate SPAM and promise to keep your email safe. Bio 6x9 Inch Coax Speakers. Strato 6. Meso 6x9 Inch Coax Speakers. Bio 6. Strao 5. Strao PA 6. Meso 6. This sub hits hard, it's running on ct sounds amp. I would like another one but my pockets are short at this time but I love ct sounds products Texas pride I will always support Texas own companies.
Thank you ct sounds. So far I love this amp.
0コメント